ilPistone.com

Rivelata la nuova versione della Zonda. Della serie precedente eredita appena il 10% delle componenti. Tutto il resto e' nuovo. La potenza passa da 650cv a ben 750 grazie al nuovo motore derivato dalla CLK GTR. Il cambio manuale-sequenziale a 6 rapporti e' accoppiato ad una frizione "racing" in grado di scaricare senza problemi i 710Nm di coppia. Il passo e' incrementato di 47mm e la geometria delle sospensioni e' nuova. La si puo' ordinare per la modica cifra di 1'200'000 euro, tasse escluse.

---

(http://www.worldcarfans.com/news/2070302.010/2070302.010.mini2L.jpg)
(http://www.worldcarfans.com/news/2070302.010/2070302.010.mini4L.jpg)
(http://www.worldcarfans.com/news/2070302.010/2070302.010.mini7L.jpg)
(http://www.worldcarfans.com/news/2070302.010/2070302.010.mini9L.jpg)

---

Worldcarfans.com (http://www.worldcarfans.com/news.cfm/newsID/2070302.010/page/1/country/ecf/pagani/pagani-zonda-r-revealed)

While we certainly cannot say the Zonda F lacks performance figures, driving around the Nürburgring in 7:32 and achieving lateral G forces of almost 1.5 G, it is however a road car, easy to drive, intuitive and setting the benchmark for comfort, safety and lightweight. Paired with a quality finish and the attention to detail this made the Zonda F one of the most desirable supercars resulting in the 25 Coupé models being sold out in record time.

This did not seem to fulfil the requirements of our most demanding customers, who adore the weekend drive on a racetrack.

The spark has been set by an Italo-American customer, enthusiast and already proud owner of 3 Zondas. He describes the project this way: ?The thought has been on my mind for quite some time, but I am not interested in racing?.

The Zonda R is born with full liberty. The target: the ultimate performance at the racetrack without any implications of rules, except for safety, where no compromise is allowed. In September 2006 the first drawings were ready, but it was crucial to have the support of Mercedes-AMG for a high revving engine with a power output of 750hp, dry sump, light and with a low centre of gravity. The basis was the self supporting engine of the mighty CLK GTR, which has dominated the GT championships.

Eve at constant racing pace the engine would have to cover over 5.000 km before servicing. The challenge has been accepted without hesitation.

The Zonda R is a car designed from scratch, with only 10% of the Zonda F components to be carried over. The suspension forged in Avional, a new Pagani six speed transversal sequential gearbox, carbon fibre monocoque, aeronautical four pump fuel tank are only part of the equation.

The wheelbase has grown by 47mm, the overall length by 394 mm and the track is increased by 50mm. The bodywork and aerodynamics have been studied to offer maximum downforce.

Even though built for the track, the project would not have received kick off, if the quality and finish of the car and its details was not up to the level of the Pagani road cars. One of the first cars to be delivered however will be kept in a living room, designed by Pagani and built with the same materials as the Zonda F, beautifully textured carbon fibre, avional, titanium, inconel and other state of the art materials. Additionally it will feature a bespoke HiFi´System that will allow the customer to listen to the sound of this car at Le Mans and the Nürburgring.

The Pagani customers who have ordered the Zonda R will be relieved of almost 1.2 million + taxes.

Technical Specifications - Zonda R

This Zonda is purpose made for track use, without restrictions of any competition rules or homologation, with the only exclusion of the passengers? integrity, where no compromise is tolerated according to our philosophy and state-of-the-art safety measures are featured.

A new heart

The engine is built by the racing specialists at Mercedes AMG, where the championship winning DTM cars are born, as well as the CLK GTR, probably the most devastating and effective weapon ever to compete in the GT series. From it?s engine the Zonda R borrows the basic architecture including an ingenious dry sump allowing a low centre of gravity. This self-supporting engine with 750 hp at 8000 rpm and 710 Nm of torque carries a lightweight carbon fibre highperformance intake system, a racing multiple disc sintered clutch and Formula 1 style exhaust system, hydroformed in Inconel 625 and ceramic coated for optimal heat dissipation. The power unit combined with a 6 speed transversal manual sequential synchronised gearbox is designed to satisfy the most ambitious drivers.

The chassis

The central carbon chassis will incorporate a roll cage and a rubber racing fuel tank with 4 fuel pumps and quick refuel filler like on GT race cars. The wheelbase has been increased by 47mm to offer the best stability. The front and rear subframes are brand-new, built to accommodate a new suspension geometry, produced in avional. The magnesium forged rims with central wheel nut and a quick pneumatic lifting system allows fast and effortless changes of the slick tyres.

Bodywork and aerodynamics

The new bodywork has been honed to offer elevated downforce even in low speed corners. The longer front bonnet with flaps, closed underbody and the rear overhang with the adjustable rear wing and race derived diffusor translate into shattering aerodynamic efficiency and will let you experience cornering speeds beyond imagination.

The car displays and logs information about the amount of dowforce that the car is generating at each moment. Combined with the adjustable wings you can easily find the best setup for each track.

Workstation

The interior is designed to accommodate the driver and passenger in bespoke seats, built to offer the best support, when the G-forces from the vehicle dynamics come into question. The Digitek instrumentation provides the essential information and a sophisticated telemetry allows through a variety of sensors to monitor every single component of the car.

peccato, l'hanno intamarrata un po' troppo  :-\

Meno male... volevo dirlo io ma temevo i tuoi insulti! ;D

Curiosità: che rapporti ci sono fra Pagani e Mercedes? È considerato un semplice cliente o una specie di partner tecnico? C'è una collaborazione, oltre alla fornitura dei motori?

Intammarata... e' praticamente una macchina da corsa...

Ciao belli!
Alla Pagani non stanno bene!
Addirittura il propulsore della CLK GTR.  Beh, quando si decidono a montare il turboreattore di un F16?

bah... di lato è veramente sgraziata! e pensare che questa è SENZA DUBBIO (non è ammesso alcun parere contrario) la più bella supersportiva del mondo

(http://www.autocity.com/img/actualidad/galerias/Pagani_Zonda_F_32_3.jpg)

il bello della zonda è che era cattivissima ma senza eccessivi alettoni o accessori strani...

Ehm....mi è permesso di dire che a me la Zonda attuale non è mai piaciuta...? ::)

Questa mi sembra non dico meglio ma già più digeribile, anche se ha troppe appendici aerodinamiche che spuntano di quà e di là, la renderanno certamente efficacissima ma non sono proprio un bel vedere...

Tanto Homer non ti può bannare, mentre io sono d'accordo con te quindi non ti bannerò nemmeno io... spera nella clemenza degli altri moderatori ;D

a me la pagani non ha mai detto molto 8)

Cattiva si. Bella no, IMHO  :P

è esclusiva quanto l'idea di farla così.
la nuova credo non sia altro che la FXX di Zonda, circoli in pista e basta.
per cui credo che l'aspetto da auto da corsa ci stia tutto

è l'equivalente di una FXX, ogni componente è finalizzato al raggiungimento della prestazione più che all'estetica. è una sport prototipo.

RIVOGLIO I SUPERPOTERIIIIIIIIIIIIIIIIIIIII!!!!!!!!!!!!!!1  >:( >:( >:( >:( >:( >:(

???

ma della zonda mi è sempre piacuto un casino l'interno, l'esterno non tantissimo.

ROTFL a me il contrario!  ;D

allora Anto viaggia fuori sul tetto e Dogui dentro bello comodo no ?

Beh è palesemente la FXX o l'MC12 della Zonda questa........non credo sia una stradale che circolerà allegramente.....o almeno lo spero..........non mi piace, troppo carica, ma se è da corsa il suo aspetto è quello che deve essere.